Wireless Information Page
41
Table 3-2. Wireless Information Page
Field
Description
Channel Bandwidth
Status (MHz)
Bandwidth, in MHz, of theTR-WMX-3.5, as defined on the Wireless Settings page (see section
2.2.1).
Frequency (KHz)
Frequency, in kHz, of theTR-WMX-3.5, as defined on the Wireless Settings page (see section
2.2.1).
RF Profile
RF profile of theTR-WMX-3.5, as defined on the Wireless Settings page (see section 2.2.1).
CP Size
Cycle prefix size, as defined on the Wireless Settings page (see section 2.2.1).
Modulation
Modulation used by theTR-WMX-3.5.
Link Manager State
Shows where in the network connection process the CPE is. For example if the CPE is scanning
for a BS downlink message, receiving a DHCP address assignment, or if the CPE to BS link is
operational.
Link State
Shows whether the TR-WMX-3.5 link is up or down.
RSSI (Received Signal
Strength Indicator)
Strength of the Received Signal Strength Indicator, in dBm, received by your TR-WMX-3.5. The
higher the value, the higher the transmit rate (up to the maximum). Conversely, the lower the RSSI,
the lower the transmission speed until 0 is reached (no connectivity).
CINR (Carrier to
Interference and Noise
Ratio)
Carrier to Interference and Noise Ratio, in dB, for your TR-WMX-3.5. The higher the value, the
more throughput a link can maintain.
Current TX Power
Current transmit power, in dBm, for your TR-WMX-3.5.
RF Mode
Current radio-frequency mode (licensed or unlicensed) for your TR-WMX-3.5.
DBPC Support (Downlink
Burst Profile Change)
Shows whether Downlink Burst Profile Change is enabled or disabled.
Initial Ranging Burst
Inverting
This feature is provided for Engineering development use, and is an undocumented feature.
Initial Delay Correction
Value
This feature is provided for Engineering development use, and is an undocumented feature.
TX Power Range Max
The maximum transmit power range of the TR-WMX-3.5, as defined on the Wireless Settings page
(see section 2.2.1).
TX Power Range Min
The minimum transmit power range of the TR-WMX-3.5, as defined on the Wireless Settings page
(see section 2.2.1).
TX Antenna Gain
The maximum transmit antenna gain of the TR-WMX-3.5, as defined on the Wireless Settings page
(see section 2.2.1).
RX Antenna Gain
The minimum transmit antenna gain of the TR-WMX-3.5, as defined on the Wireless Settings page
(see section 2.2.1).
AFS Channel Bandwidth
(in MHz) Scan Order
This feature is provided for Engineering development use, and is an undocumented feature.
MRTR for SMC in bps
The minimum reserved traffic rate for the secondary management channel.
Lost DL/UL MAP Interval
([600 , 1800]
milliseconds)
The time in seconds that the CPE will maintain the link to the BS using the last DL or UL MAP
received.
AFS Mode
This feature is provided for Engineering development use, and is an undocumented feature.
RNG-RSP Byte Order
This feature is provided for Engineering development use, and is an undocumented feature.
