111111
This document is intended for Public Distribution
19473 Fraser Way,
Pitt Meadows, B.C. Canada V3Y 2V4
Chapter 3: Configuration
3-11
TR-49 Series
Tranzeo Wireless Technologies
Wireless Settings - Advanced Tab, Access Point
This window displays the advanced wireless configuration of the device. The
contents are slightly different for access point and CPE.
(1)
In the FCC Domain this setting has no effect.
RTS Threshold:
This is the maximum size for a packet to be sent
automatically. When it exceeds the RTS threshold, the
CPE sends first a ‘request to send’ (RTS) to the access
point before sending the packet.
Note: The more clients you have, the lower the value
should be set.
Fragmentation
Threshold:
This is the size at which packets are fragmented in
order to be transmitted. Setting this value too low
decreases the amount sent on each transmission. In
noisy areas, this can improve performance. However,
in quiet areas, this will decrease throughput.
ACK Timeout Tuning:
The time that the radio waits for an acknowledgment
(ACK) from the access point accepting transmission
before re-attempting to send the data. This is an offset
from the ACK timing set by the link distance.
Beacon Interval:
This is the rate at which the access point broadcasts its
beacons.
DTIM Interval:
The DTIM interval (Delivery Traffic Indication
Message) helps to keep marginal clients connected by
sending wake up frames.
Burst Time:
This allows to send data without stopping. Note that
other wireless devices in the network will not be able
to transmit data for this number of microseconds.
802.11d Enabled:
Check to operate in 802.11d mode.
(1)
Preamble:
Select type:
Long
uses long preamble only,
Auto
(recommended) tries short preamble first, then long.
