Transtherm Bastide, Technical Manual

Page: 23 / 100

GB
English - P 7
Shelf in sliding version configuration:
To place bottles on a sliding shelf, carry out the following:
- Install the shelf in the selected location.
- Place a wooden locking pin in each of the two holes located on the
right and left of the upper face approximately 4cm to the rear of
the shelf: when the shelf is slid forwards, these pins stop it from
sliding completely out of the cabinet (See diagram).
- Start by placing the bottles in the rear recesses with the base of the
bottles towards the back.
- Continue by placing the bottles in the front recesses facing them in
the opposite direction.
- A sliding shelf can only hold one layer of bottles (maximum of 13
"Tradition" Bordeaux bottles).
- In order to enjoy optimum accessibility when setting up the cabinet in a
mixed layout, we recommend that shelves destined to be used as sliding
shelves are located in the middle section of the cabinet.
NEVER SLIDE MORE THAN ONE SHELF.
You should remember that if you do not have enough bottles to fill
your wine cabinet, it is better to distribute the load over all of the
shelves available, so as to avoid "all on top" or "all below" type loads.
ecommendation
The shelves all have a label slot, designed to receive the pre-cut cards
delivered with your cabinet, thus helping you to identify the position
of your favourite wines at a glance.
important
Rearrange the locking pins when changing from sliding shelf to storage or
presentation shelf.
Notice Elégance 5L.qxd 11/07/07 11:17 Page 23