Transition Networks
SM24TAT2DPA Install Guide
33702 Rev. A
https://www.transition.com
Page
7
of
23
--
Off
The port has no active network cable connected, or it is not
established a link to connected device. Otherwise, the port
may have been disabled through the switch user interface.
When PoE Mode LED Lit
LED Color State
Description
RJ45
Ports
Green On
The port is enabled and supplying power to connected device.
Amber On
An abnormal state, such as overload status, has been detected
in the switch.
--
Off
The port has no active network cable connected, or it is not
connected a PoE PD device. Otherwise, the port may have been
disabled through the switch user interface.
Mode/Reset button
Press the
Mode/Reset
button for a specific period of time to perform these tasks:
□
Change Port Status LED Mode
: to read the port status correctly in the two different modes
(Link/Act/Speed mode or PoE mode).
□
Reset the Switch
: to reboot and get the switch back to the previous configuration settings saved.
□
Restore the Switch to Factory Defaults
: to restore the original factory default settings back to the
switch.
Note
: The table below describes the task being performed by reading the LED behaviors while pressing
the Mode/Reset button. Once the LED behaviors are correctly displayed, you may release the button.
Table 1: Mode/Reset Button Descriptions
Task to Perform
Press the Button for
SYS LED
Behavior
Port Status LED Behavior
Change LED Mode
0 ~ 2 seconds
ON
Green
LED status will change based on the
mode selected.
Reset the Switch
2 ~ 7 seconds
Blinking
Green
All LEDs OFF
Restore to Defaults
7 ~ 12 seconds
Blinking
Green
All LEDs Stay ON
