Transition Networks
SISTP1040-382B-LRT Install Guide
33806 Rev. B
Page 32 of 39
Caution: Copper based media ports, e.g., Twisted Pair (TP) Ethernet, USB, RS232, RS422, RS485, DS1, DS3, Video Coax,
etc., are intended to be connected to intra-building
(inside plant)
link segments that are not subject to lightning transients or
power faults. They are not to be connected to inter-building
(outside plant)
link segments that are subject to lightning.
Caution: Do not install the device in areas where strong electromagnetic fields (EMF) exist. Failure to observe this
caution could result in poor device performance.
Caution: Read the installation instructions before connecting the chassis to a power source. Failure to observe this
caution could result in poor performance or damage to the equipment.
Caution: Only trained and qualified personnel should install or perform maintenance on the device. Failure to observe
this caution could result in poor performance or damage to the equipment.
Caution: Do not let optical fibers come into physical contact with any bare part of the body since they are fragile, and
difficult to detect and remove from the body.
Caution: Do not bend any part of an optical fiber/cable to a diameter that is smaller than the minimum permitted
according to the manufacturer’s specification (usually about 65 mm or 2.5 in)!
Warnings
Warning: Use of controls, adjustments or the performance of procedures other than those specified herein may
result in hazardous radiation exposure.
Warning: Visible and invisible laser radiation when open. Do not stare into the beam or view the beam directly with
optical instruments. Failure to observe this warning could result in an eye injury or blindness.
Warning: DO NOT connect the power supply module to external power before installing it into the chassis. Failure
to observe this warning could result in an electrical shock or death.
Warning: Select mounting bracket locations on the chassis that will keep the chassis balanced when mounted in the
rack. Failure to observe this warning could allow the chassis to fall, resulting in equipment damage and/or possible injury to
persons.
Warning: Do not work on the chassis, connect, or disconnect cables during a storm with lightning. Failure to observe this
warning could result in an electrical shock or death.
High Risk Activities Disclaimer: Components, units, or third-party products used in the product described herein are
NOT fault-tolerant and are NOT designed, manufactured, or intended for use as on-line control equipment in the following
hazardous environments requiring fail-safe controls: the operation of Nuclear Facilities, Aircraft Navigation or Aircraft
