6.2.3 FILTER
SETTING
This function is used to set the scale’s response time versus stability. A filter setting of zero
gives you a fast response, but little stability. A filter setting of 2 gives you the maximum
stability, but is a little slower. A filter setting of 1 is a compromise between the first two
settings. If you are using the scale for rate computation, it is suggested that you use a
setting of 2.
1. Enter the Setup Menu Mode as described above and press the ENTER key until the
scale prompts ” Filter OK?” and displays the current setting (0-2) of the filter.
2. Press the ENTER (Yes) key to accept the displayed filter setting or press the REMOTE
SCALE (No) key to change the filter setting.
Note:
If
“Yes”
is selected, the scale proceeds to the Buzzer Setup. If
“No”
is selected,
the message “Filter? (0-2)” appears in the display.
3. Using the numeric keys, enter the new filter setting. The scale prompts ” Filter OK?” and
displays the current filter setting. Repeat Step 2.
6.2.4 BUZZER
ENABLE/DISABLE
This function is used to enable or disable the audible tone heard when a key is pressed.
1. Enter the Setup Menu Mode as described above and press the ENTER key until the
scale prompts ” Keypad Beep OK?” and displays the current status (ON/OFF) of the
buzzer.
2. Press the ENTER (Yes) key to accept the displayed buzzer status or press the
REMOTE SCALE (No) key to change the buzzer status.
Note:
If
“Yes”
is selected, the scale proceeds to Exit Setup Mode. If
“No”
is selected,
the status toggles between ON and OFF.
6.2.5 EXIT SETUP MODE
This function is used to exit the Setup Mode and return to Normal Operating Mode.
1. After the Buzzer status is set, the scale prompts ” Exit Setup? Y/N”.
2. Press the ENTER (Yes) key to return to normal operating mode or press the REMOTE
SCALE (No) key to start over with the ZIP code entry.
Page 6-2
