TrangoFOX™ Subscriber Unit User Manual
Trango Broadband Wireless
Page
9
Configuration Page Parameters
Base ID:
User definable integer 1-127. The AP that this SU will communicate with must have a matching Base ID
loaded into its memory. Can only be changed while opmode is OFF.
AP ID:
User definable integer 1-255. Identifies which AP that this SU will attempt association with. Can only be
changed while opmode is OFF. NOT USED BY SYSTEM FOR AUTHENTICATION PURPOSES.
SU ID:
The identification number assigned by the administrator which must also reside in the AP database.
IP Address:
The IP address of the SU for use in Telnet, HTTP, SNMP, TFTP.
Subnet Mask:
The subnet mask of the SU for use in Telnet, HTTP, SNMP, TFTP
Gateway IP:
Default gateway of the SU for use in Telnet, HTTP, SNMP, TFTP
Default Opmode:
Opmode the radio will enter after approximately 30 sec after power on provided no attempt to
connect via Telnet is made.
Switches:
Checked means active
Block Broadcast and multicast packets - Block these type Ethernet packets when active- ARP packet
will be passed however.
Auto Scan AP - Activates channel and polarization scan sequence below.
TCP/IP service for AP - Allows the AP to telnet and HTTP into the SU via the RF link when SU
opmode is "SU".
TCP/IP Service for Ethernet Port – Allows telnet and HTTP access to SU from Ethernet port regardless
of opmode.
Scan AP sequence:
The current channel and antenna polarizations used the SU uses while searching for an AP to
associate with. Opmode must be "SU" and Auto Scan AP must be activated.
Remarks:
A text field available for system administrator general use. Does not affect system performance.
Save and Activate Settings:
Saves the variables to FLASH memory and activates setting.
Activate Opmode:
Activates the default opmode. Must be clicked to activate the opmode after changing.
Reboot System:
Reboots the system. Make sure all settings have been saved first.
Advanced
Setup
In order to optimize your wireless link it may be necessary to reassign channels or change the receivers RF Threshold. To
access these parameters, click on the
Advanced Setup
link.