98/115
V07-19.0
Parameter
Value
Description
General:
Module configuration/info
Software version
Display software version
Device ID
Display device ID
Module
Display module information
Use default
Active
Set back to the default settings
Table 40:
LON configuration
22.2.5
Modbus RTU/ IP controller interfaces
Directly on controller there are 2 communication ports available (1 for IP and 1 for RTU). The IP in-
terface you can use for Web-Application (within your network), where you can monitor the same sit-
uation like on the local HMI display.
Modbus RTU (on board) has no galvanic isolation and is just to use for building management; if
power measurement will be done over IP, connection to BMS is not possible!
The configuration is carried out in the menu
Configuration
Communication controller
.
Parameter
Value
Description
IP-Config: (TCP-Port: 502)
IP
Display IP address of controller
Mask
Display subnet mask
Gateway
Display gateway address
DHCP
Display DHCP status (automatic reference of IP address from a DHCP
server)
Name
Controller name
MAC
Display MAC address
Change settings
Submenu IP configuration
IP
Config of IP address of controller
Mask
Config of subnet mask (controller)
Gateway
Config of gateway address (controller)
DHCP
Config DHCP [Active]
Passive
Manual address config
Active
Automatic address config by DHCP server
100 Mbit
Switch-over interface speed 10/100Mbps [Active]
Passive
Speed 10Mbps
Active
Speed 100Mbps
Link
Activate IP interface [Active]
Passive
Interface deactivated (no communication)
Active
Interface activated
User name
User name for WebVisu
