ATTACH WITH COUPLER SET
7
1.
If the Coupling Plate is not already installed
with the Ball Base, detach the ball from the
Base, slip the Coupling Plate under the ball,
and reinsert into the Base. Secure tightly.
2.
Place the Ball Base into the Base tower and
secure with included pin. Then secure the Ball
Base Tower into the slot on top of the RVR in
place of the Mount Bracket Tower.
3.
Raise the trailer tongue above the height of
the Hitch Ball in order to slip the ball into the
coupler and lock the with the coupler latch.
4.
Using the Spanner Wrench, turn the Locking
Nut counter clockwise until the nut is secured
flat against the coupler.
WARNING!
Failure to tighten the Locking Nut
against the coupler may cause the ball to slip
out of the coupler.
CHARGING THE RVR12
1.
Before charging your RVR12, be sure the radio and tug are both turned OFF.
2.
The charging indicator light on the charger should light up red once the charger
is connected properly. The tug will be fully charged once the charge indicator light
turns green.
It is recommended to leave the tug charging when not in use.
3.
Once it is fully charged, unplug the charger and turn the tug on. Then turn the
tug off for a few seconds and back on again. This will resets the tug. It is now
ready to be used.
Charging Indicator
Light
Charging Jack
Summary of Contents for RVR12
Page 1: ...OPERATING MANUAL RVR12...
