REMOTE CHARGING & BATTERIES
12
CHARGING THE REMOTE CONTROL
WARNING: Only use the supplied charger to charge the remote control when
using the supplied batteries or the following:
- 1200mAh Ni-MH or Ni-Cd ‘AA’ Rechargeable Batteries
The use of the remote charger with alkaline batteries installed can damage
the remote control. Do not use the charger if alkaline batteries are installed in
the remote control.
1.
Plug the remote control charger into a 110v AC wall socket.
2.
Plug the connector from the charger into the charging jack on the remote
control. The charging indicator LED, located on the side of the remote control, will
illuminate green indicating the remote control is charging. Once the remote control
is fully charged the charging indicator LED will turn off.
3.
The charging rate of the charger is 150mAh. When using the 1200mAh batteries
that are supplied, the controller requires a 2-4 hour charge when fully discharged
(1200/150=8). If using 2200mAh batteries, it will take approximately 4-6 hours to
recharge (2200/150=14.6).
It is recommended to keep the transmitter charging when not in use.
Charging
Indicator
LED
Charging
Port
Summary of Contents for RVR12
Page 1: ...OPERATING MANUAL RVR12...
