TrackWeight BRT 5, Installation Manual

Page: 19 / 31

Installation Manual | V1.0.0 | 19
3. Place the fixed and adjustment block at the center of the width of the chosen
location on the structure (axis or "beam"). The blocks should be placed face-to-face
within 50 ± 2 mm of each other.
Note: If you have the BRT9081 installation assistance tool, you only need to make
sure you find the center of the beam width and check the clearance.
4. Use pliers to hold the blocks in place before welding.
5. Preheat around blocks up to 65 ° C.
6. "Stop" each outside corner of the two blocks to the structure. See Figure p. 20.
IMPORTANT: The use of the welding rod or 309L-16 wire, rustproofing, or 7018,
steel, is mandatory. See Appendix 2 for rustproofing weld procedures
BRT9081 installation
assistance tool
Section to be measured
Centre of the section to
be measured
Centre
Centre
Centre Centre