TrackWeight BRT 5, Installation Manual

Page: 18 / 31

Installation Manual | V1.0.0 | 18
Installation
1. Determine the correct location for sensor installation.
Note: Make sure that the RT sensor does not interfere with fixed or moving parts of
the vehicle.
› For the front axle(s): Ideally in the center of the axle. However, be sure to check
the clearance of the truck and have a good clearance (with the protective
cover) so that the sensor does not catch on the oil pan or any other part of the
truck.
› For rear axles: Place the sensors in opposite positions, ideally centered
between the "bushing" and the wheel. Make sure there is at least 10 cm
clearance between the sensor and the wheel. The sensor on the driver's side
must be on the back of the axle and the one on the passenger side must be on
the front of the rear axle group.
2. Prepare the "beam" structure for welding by removing any paint, rust and/or other
potential contaminants.