23 |
Place the special heater tool between the
heater and the socket, and lift the lamp
out of its socket. Lift the front side of the
heater with two hands. Pull it slightly
to the front to release it from the rear
socket and lower it out from under the rear
deflector.
Take the new heater from its protective
package and place it in the same way as
the original heater was positioned using
the heater placement tool.
The pin on the bottom of the heater
must be positioned correctly. For a more
uniform heat distribution these are
mounted alternating. On the uneven
positions on the back side and at the
even to the front.
Before proceeding always wear the
supplied cotton gloves to prevent
contamination from the hands to be
transferred to the lamps. Contamination
on the heaters will significantly reduce the
lifetime expectancy.
Align the placed heater such that it is
pointing upward. Assure all other lamps
are correctly aligned as well.
Place the front deflector.
Place the back deflector.
12
13
14
15
16
Gently remove the front deflector by
sliding it out upwards from between the
lamps.
Gently remove the back deflector by
sliding it out upwards from between the
lamps.
10
11
Summary of Contents for CureView AB8000
Page 2: ......
Page 28: ......
Page 30: ...30 Date Name Signature Signature Instructed by Operator list...
