TQC CureView AB8000, Operating Instructions Manual

Page: 17 / 32

17 |
12.5.1 General setup
Use the general setup page to specify a name for the panel under test. In IFA
the name of panel will be used as identification for the temperature profile.
Use Temperature units to override the default setting in this configuration
only.
Start run:
Command to switch the program in run mode and skip any remaining steps
from the setup mode stage enumerator. Use this command to switch to run
mode instantly for example after opening a configuration file.
Cancel run:
Command to cancel the current run and switch to program to setup mode.
Use the red button on the front of the gradient oven to obtain the same
result.
Proceed:
Command to step to the next stage in the setup mode stage enumerator,
obtain the same result as selecting a stage by mouse. The command will
switch the program into run mode if the Pre-cooling stage was previously
selected. Use the green button on the front of the gradient oven to obtain
the same result.
12.5.2 Pre-cooling setup
The gradient oven cooling zone consists of five Peltier cooling elements
that can cool down the panel under test. The cooling zone is not
temperature controlled and only driven by a predefined power and
duration. Use the pre-cooling setup to configure the cooling power and
duration in the cooling zone that shall be applied to the panel under test
prior to the heating stage.
Power (%):
Defines the amount of cooling in percentage of the gradient oven cooling
system.
Duration (s):
Defines the amount of time in seconds that the cooling shall be applied.