TL-WR941ND
Wireless N Router
)
Note:
The default PIN code of the Router can be found in its label or the QSS configuration screen as
Figure 4-2
.
c). You will see the following screen when the new device successfully connected to the
network.
)
Note:
1. The status LED on the Router will light green all the time if the device has been successfully
added to the network.
2. The QSS function cannot be configured if the Wireless Function of the Router is disabled.
Please make sure the Wireless Function is enabled before configuring the QSS.
4.5 Network
Figure 4-4 the Network menu
There are three submenus under the Network menu (shown in Figure 4-4):
LAN
,
WAN
and
MAC
Clone.
Click any of them, and you will be able to configure the corresponding function.
4.5.1 WAN
Choose menu “
Network
→
WAN
”, you can configure the IP parameters of the WAN on the screen
below.
1. If your ISP provides the DHCP service, please choose
Dynamic IP
type,
and the Router will
automatically get IP parameters from your ISP. You can see the page as follows (
Figure 4-5
):
-25-
