TL-WR941ND
Wireless N Router
¾
Channel -
This field determines which operating frequency will be used. The default
channel is set to
Auto
, so the AP will choose the best channel automatically. It is not
necessary to change the wireless channel unless you notice interference problems with
another nearby access point.
¾
Mode -
This field determines the wireless mode which the Router works on.
¾
Channel Width -
Select any channel width from the pull-down list. The default setting is
automatic, which can adjust the channel width for your clients automatically.
¾
Max Tx Rate -
You can limit the maximum transmission rate of the Router through this
field.
¾
Disable Security -
The wireless security function can be enabled or disabled. If
disabled, the wireless stations will be able to connect the Router without encryption. It is
recommended strongly that you choose one of following options to enable security.
¾
WPA/WPA2-Personal -
Select WPA based on pre-shared passphrase.
z
Password
- You can enter
ASCII
or
Hexadecimal
characters.
For
ASCII
, the key can be made up of any numbers 0 to 9 and any letters A to Z, the
length should be between 8 and 63 characters.
For
Hexadecimal
, the key can be made up of any numbers 0 to 9 and letters A to F,
the length should be between 8 and 64 characters.
Please also note the key is case sensitive, this means that upper and lower case
keys will affect the outcome. It would also be a good idea to write down the key and
all related wireless security settings.
¾
No Change -
If you chose this option, wireless security configuration will not change!
These settings are only for basic wireless parameters. For advanced settings, please refer to
4.6 Wireless.
6. Click
the
Next
button. You will then see the
Finish
page.
If you don’t make any changes on the
Wireless
page, you will see the
Finish
page as shown
in Figure 3-12. Click the
Finish
button to finish the
Quick Setup
.
Figure 3-12 Quick Setup – Finish
If there are something changed on the
Wireless
page, you will see the
Finish
page as shown in
Figure 3-13. Click the
Reboot
button to make your wireless configuration to take effect and finish
the
Quick Setup
.
-15-
