48
Chapter 4
Configure the Access Point
• SysContact
- The textual identification of the contact person for this managed node.
• SysName
- An administratively-assigned name for this managed node.
• SysLocation
- The physical location of this node.
Note:
If you are not familiar with the setting items on this page, it’s strongly recommended to keep the provided default values;
otherwise it may result in lower wireless network performance.
• Get Community
- Enter the community name that allows Read-Only access to the
Device’s SNMP information. The community name can be considered a group
password. The default setting is “public”.
• Get Source
- Get source defines the IP address or subnet for management systems
that can read information from this ‘get’ community device.
• Set Community
- Enter the community name that allows Read/Write access to the
Device’s SNMP information. The community name can be considered a group
password. The default setting is “private”.
• Set Source
- Set source defines the IP address or subnet for management systems
that can control this ‘set’ community device.
Note:
A restricted source can be a specific IP address (e.g. 10.10.10.1), or a subnet - represented as IP/BITS (e.g. 10.10.10.0/24).
If an IP Address of 0.0.0.0 is specified, the agent will accept all requests under the corresponding community name.
4. 5. 2. Diagnostic
Diagnostic is used to test the connectivity between the access point and the host or
other network devices.
1. Visit
, and log in using
admin
(all lowercase) for both username and password.
2. Go to
System Tools
>
Diagnostic
.
Downloaded from
