Toyotomi UTG-09AP, User Manual

Page: 68 / 156

68
GB
INTRODUCTION FOR BUTTONS OF REMOTE CONTROLLER
Note:
q
This is a general use remote controller, it could be used for the air
conditioners with multifunction. For some functions, which the model does
not have, if press the corresponding button on the remote controller that
the unit will keep the original running status.
q
After putting through the power, the air conditioner will give out a “beep”
sound. Operation indicator is ON (red indicator). After that, you can
operate the air conditioner by using the remote controller.
q
Under on status, pressing the button on the remote controller, the signal
icon
on the display of remote controller will blink once and the air
conditioner will give out a “de” sound, which means the signal has been
sent to the air conditioner.
q
Under off status, set temperature and clock icon will be displayed on the
display of remote controller (If timer on, timer off and light functions are
set, the corresponding icons will be displayed on the display of remote
controller at the same time). Under on status, the display will show the
corresponding set function icons.
1 On/Off button
Press this button to turn on the unit. Press this button again to turn off the unit.
2 MODE button
Each time you press this button, a mode is selected in a sequence that goes
from AUTO, COOL, DRY, FAN and HEAT, as following:
3 FAN button
This button is used for setting Fan Speed in the sequence that goes from
AUTO, , to
, to then back to Auto.
Note:
• Fan speed under dry mode is low speed.
•
X-FAN function: Hold fan speed button for 2 seconds in COOL or DRY
mode, the icon
is displayed and the indoor fan will continue operation
for a few minutes in order to dry the indoor unit even though you have
AUTO COOLD RY FAN HEAT LD