Toyotomi UTG-09AP, User Manual

Page: 83 / 156

83
GB
of drill head should be same as the plastic expansion particle) and then fi ll
the plastic expansion particles in the holes
3. Fix the wall-mounting frame on the wall with tapping screws and then check
if the frame is
fi rmly installed by pulling the frame. If the plastic expansion
particle is loose, please drill another fi xing hole nearby.
Step three: Open piping hole
1. Choose the position of piping hole according to the direction of outlet pipe.
The position of piping hole should be a little lower than the wall-mounted
frame, shown as below.
NOTE:
§
The wall panel is for illustrative purposes only, please refer to the actual
installation.
§
The wall panel is for illustrative purposes only, please refer to the actual
installation. Please refer to the actual circumstances for the number of
screws and the position of screws.
2. When installation is fi nished, pull the mounting nut with torque wrench.
Plate with hand to con fi rm whether it is fi xed tightly. The force distribution
for all screws should be uniform.
3. Open a piping hole with the diameter of Φ 55 or Φ 70 on the selected outlet
pipe position. In order to drain smoothly, slant the piping hole on the wall
slightly downward to the outdoor side with the gradient of 5-10°.
space to the
wall aove
150mm
space to the
wall aove
150mm
wall
wall
(rear piping
hole)
(rear piping
hole)
(for some
models)
level meter
mark in the middle of it
Right
Left
Φ 55mm
Φ 70mm
Φ 55mm
Φ 70mm