Toyota OEKAKI 50, Instruction Manual

Page: 97 / 106

97
EN
* Although the above code will disappear after 2 to 3 seconds, the necessary countermeasure should be
performed.
Note
• If the problem is not resolved after the appropriate countermeasure is performed, stop using
the sewing machine and contact your retailer.
• A code between E1 and E9 appearing indicates that the sewing machine has malfunctioned.
Immediately stop using the sewing machine and contact your retailer.
F9
This appears when any of the following
incorrect operations are performed. (The
sewing machine does not operate.)
1 You try to start the sewing machine with
the start/stop button while the foot
controller is connected.
1 When the foot controller is connected,
start the sewing machine with it.
2 In OEKAKI mode, the start/stop button
or reverse sewing button is pressed.
2 In OEKAKI mode, use the foot
controller.
3 The reverse sewing button is pressed
while a buttonhole stitch is selected.
3 Use the start/stop button or foot
controller with buttonhole stitches.
4 While the bobbin is being wound, the
needle up/down button or reverse
sewing button is pressed.
4 When winding the bobbin, use the start/
stop button or foot controller.
P0 – 9
or PF
This appears when an incorrect operation
was performed with the sewing machine
turned on. Since the sewing machine is in service
mode, turn it off, then on again.
LED display Cause Countermeasure