
341
5-12. Bluetooth
®
5
Au
dio
sy
s
tem
HILUX_OM_OM0K198E_(AE)
X
When using the Bluetooth
®
message function
X
In other situations
Messages cannot be viewed.
Message transfer is not enabled on the cellular phone.
→
Enable message transfer on the cellular phone (approve message
transfer on the telephone).
Automatic transfer function on this system is set to off.
→
Set automatic transfer function on this system to on. (
→
P. 336)
New message notifications are not displayed.
Notification of SMS/MMS/E-mail reception on this system is set to off.
→
Set notification of SMS/MMS/E-mail reception on this system to on.
(
→
P. 336)
Automatic message transfer function is not enabled on the cellular phone.
→
Enable automatic transfer function on the cellular phone.
X
Vehicles without smart entry & start system
The Bluetooth
®
connection status is displayed at the top of the screen each
time the engine switch is turned to the “ACC” or “ON” position.
X
Vehicles with smart entry & start system
The Bluetooth
®
connection status is displayed at the top of the screen each
time the engine switch is turned to ACCESSORY or IGNITION ON mode.
Connection confirmation display on this system is set to on.
→
To turn off the display, set connection confirmation display on this
system to off.
Even though all conceivable measures have been taken, the symptom sta-
tus does not change.
The cellular phone is not close enough to this system.
→
Bring the cellular phone closer to this system.
The cellular phone is the most likely cause of the symptom.
→
Turn the cellular phone off, remove and reinstall the battery pack,
and then restart the cellular phone.
→
Enable the cellular phone’s Bluetooth
®
connection.
→
Stop the cellular phone’s security software and close all applica-
tions.
→
Before using an application installed on the cellular phone, care-
fully check its source and how its operation might affect this sys-
tem.
HILUX_OM_OM0K198E_(AE).book Page 341 Thursday, February 12, 2015 6:39 PM
NOT
FOR
REPRODUCTION