TOX PRESSOTECHNIK Powerpackage Q Series, Original Operating Instructions, Page: 63 / 80

Maintenance
TOX_Manual_Powerpackage_line-Q_en
63
ü
System is in maintenance position.
See
Set system to maintenance position, Page 59 .
1. Remove venting plate with locking wire.
2. Unscrew knurled cap of the oil filling nipple.
3. Vent filling hose of the oil pump.
4. Install filling hose of the oil pump on oil filling nipple.
5. CAUTION! Splashing oil! Open vent screw slowly!
Unscrew corresponding vent screw (see table "Venting point according
to installation position") by 2 turns.
- OR -
Unscrew corresponding high pressure measuring connection cover
(see table "Venting point according to installation position:") and push
in with a blunt object (e.g. a pin).
6. Continue to fill until oil escapes from the open vent hole free of bubbles.
7. CAUTION! Risk of injury and risk of slipping from leaking oil! Absorb oil
immediately and without residue!
8. Wait 10 min. Afterwards, repeat filling procedure until oil escapes from
the open vent hole free of bubbles.
9. Unscrew filling hose of the oil pump.
10. Tighten vent screw.
- OR -
Close high pressure measuring connection.
11. Screw in knurled cap of the oil filling nipple.
12. Install venting plate.
13. Fasten locking wire.
14. NOTE! Device damage due to overfilling!
Lower oil level.
See
Lowering of oil level, Page 64 .