TOX PRESSOTECHNIK Powerpackage Q Series, Original Operating Instructions, Page: 62 / 80

Maintenance
62 TOX_Manual_Powerpackage_line-Q_en
The top vent screws or the top HP measuring connection must be selected
for the venting.
Venting points according to installation position
Installation position Type Q-S Type Q-K
Vertical, working piston
downward Vent screw 2 Vent screws 2, 4, 6, 5, 7
Vertical, working piston
upward Vent screw 1
HP measuring connection
8 Vent screws 3, 5
HP measuring connection
8
Horizontal, operating side
facing upward Vent screw 2
HP measuring connection
8 Vent screws 2, 3, 5, 6, 7
HP measuring connection
8
Tab. 4 Venting point according to installation position
WARNING
Contusions caused by uncontrolled extending working piston!
Serious contusions and injuries on hand and fingers.
è
Make sure that the return stroke is impinged with compressed air.
è
Make sure that fast approach stroke and power stroke cannot be acti-
vated.
è
Install a restraint device if necessary.
è
If no valve block ZVX is installed, turn off compressed air supply of the
pressure valve.
CAUTION
Environmental pollution caused by environmentally harmful liquids!
è
Absorb spilled liquids and remove without residue.
è
Dispose of liquid according to the statutory regulations.
NOTE
Damage caused by trapped air!
è
Vent drive after filling with oil.
è
Use highest vent screw or high pressure measuring connection for
venting.