Program Mode
(To preset up to two on and off periods per
day)
The program mode has two settings for
weekdays and two for weekends. The hand
held remote comes with the following pre
programmed settings:
Weekday Program
(Monday through Friday)
Program one (P1) turns ON at 7:00am and
turns OFF at 8:00am
Program two (P2) turns ON at 5:00pm and
turns OFF at 7:00pm
Weekend Program
(Saturday and Sunday)
Program one (P1) turns ON at 9:00am and
turns OFF at 10:00am
Program two (P2) turns ON at 6:00pm and
turns OFF at 9:00pm
Activate the programs by pressing the program
button on the lower left hand side of the remote
hand set. (Fig. #53)
To customize these settings:
1. Hold the program button down until the
display flashes. (P1, weekday ON time -
[Fig. #54])
2. Use the up and down buttons to change
the time to the desired ON time.
3. By pressing the OK button, the P1 weekday
OFF time will flash. (Fig. #54)
4. Use the up and down buttons to set the
desired OFF time.
5. Press the OK button and the P2 weekday
ON time will flash.
6. Repeat the process to set the P2 weekday,
P1 weekend and P2 weekend programs.
7. When the P2 OFF time is set and the OK
button is pressed the display will stop
flashing and the remote will be in program
mode.
The program settings are now stored in the remote handset and will not change unless the
above process is repeated or the batteries are removed from the handset.
To switch out of program mode, simply press one of the manual, timer or thermostat mode
buttons. Please note that if the manual button is pressed it will turn the fireplace off.
Fig. #51
TIMER
Fig. #52
TIMER
RUN
DISPLAY
PROGRAM
Fig. #54
Fig. #53
30
TCWS.54CE3 2/0313-44
Summary of Contents for TCWS.54CE3
Page 40: ...40 TCWS 54CE3 2 0313 44 ...
Page 41: ...41 TCWS 54CE3 270313 44 ...
Page 42: ...42 TCWS 54CE3 2 0313 44 ...