Adjustable Lintel
Fig. #16
Fig. #17
Fig. #18
1. The adjustable lintel assembly has two
orientations for desired finishing. A flanged
edge and a hemmed edge. The lintel comes
factory installed with the flange edge out. If
the desired edge is different from the factory
setting, use the following steps to change
it(Fig.#21).
2. Remove the window trim (Fig.#22).
3. Loosen the securing bolts in the upper and
lower corners on each side of the lintel
and remove the lintel. Rotate the assembly
to have the desired edge away from the
fireplace(Fig .#23).
4. The lintel assembly has a maximum range
of adjustability of 1” to accommodate varying
facing material thicknesses. The maximum
depth is 6” (Fig.#25).
5. The lintel assembly can then be adjusted
to align flush with your facing material by
sliding in or out approximately 1”.
6. Tighten the securing bolts. (Fig.#23).
7. Re-attach the window trim.
HEMMED EDGE
FLANGED EDGE
TRIM
SECURING
BOLT
13
TCWS.54CE3 270313-44
Summary of Contents for TCWS.54CE3
Page 40: ...40 TCWS 54CE3 2 0313 44 ...
Page 41: ...41 TCWS 54CE3 270313 44 ...
Page 42: ...42 TCWS 54CE3 2 0313 44 ...
