1. Remove the 2 inner screws from the upper heat shield. (Fig. #41)
2. Slip the top porcelain panel into the lip at the front of the firebox and tip
the panel up to align with the screw holes. Secure with the previously removed
screws. (Fig. #42)
3. Insert the back panel into the firebox by tilting the panel and rest the panel
on the seat tabs at the back of the firebox. (Fig. #43)
NOTE: Seat tabs can be lowered if the rear panel is tight.
NOTE: Centering tabs on the panel should be located at the outside of the
seat tabs.
4. While supporting the back panel insert the left side panel into the firebox.
Position the top of the panel against the side of the unit, inserting the top panel
tab into the slot at the top of the side panel and slide the bottom into position.
(Fig. #44)
NOTE: Notch at bottom of side panel faces to front of unit.
5. Repeat step 4 for the other side panel.
NOTE: Install burner now.
6. Place the front panel on the front lip of the firebox, wide flange facing the
front. (Fig. #45)(Proceed to step #7 if you are installing a TCWS.54NG03.C2
Black Diamond burner with this unit.)
7.
Place the other front panel piece at the rear of the firebox with the
wide flange facing to the rear against the back panel.
Fig. #41
Fig. #42
Fig. #44
Fig. #43
Fig. #45
SEAT TABS
25
TCWS.54CE3 270313-44
Firebox Panels Installation
Summary of Contents for TCWS.54CE3
Page 40: ...40 TCWS 54CE3 2 0313 44 ...
Page 41: ...41 TCWS 54CE3 270313 44 ...
Page 42: ...42 TCWS 54CE3 2 0313 44 ...
