Adjustable Lintel
1. The adjustable lintel assembly
has two orientations for desired
finishing. A flanged edge and a
hemmed edge. The lintel comes
factory installed with the flange
edge out. If the desired edge is
different from the factory setting,
use the following steps to change
it (Figure 22).
2. Remove the window trim by
lifting and pulling to disengage
from the window frame (Figure
23).
3. Loosen the securing bolts in the
upper and lower corners on each
side of the lintel and remove
the lintel (Figure 24). Rotate the
assembly to have the desired
edge away from the fireplace.
4. The lintel assembly has a
maximum range of adjustability
of 1” to accommodate varying
facing material thicknesses. The
maximum depth is 6” (Figure 25).
5. The lintel assembly can then be
adjusted to align flush with your
facing material by sliding in or
out approximately 1”.
6. Tighten the securing bolts
(Figure 24).
7. Re-attach the window trim.
Hemmed edge
Flanged edge
Figure 22: Adjsutable lintel.
Trim
Figure 23: Trim.
Securing bolt
Figure 24: Lintel securing bolt.
15
TC36.CODE_271119-40
100003879
