9
❏
13. While the servo is still operational move the aileron
up and down to check for smooth movement. Make any
adjustments necessary.
❏
14. Prepare the other wing with the aileron servo the
same way.
ASSEMBLE THE FUSELAGE
Prepare the Fuselage for the Stab & Fin
❏
1. If you haven’t yet done so, address any covering issues
on the fuselage and the tail parts as described on pages 4
and 5.
❏
2. Cut the covering from the fuselage over the rudder
pushrod exit and both elevator pushrod exits and from the
stab and fi n slots. Remove the temporary
fi ller block
from
the stab slot.
❏
3. Also cut the covering from both sides over the wing
tube holes, the alignment peg holes, the slots for the wing
retainers and for the aileron servo wires.
❏
4. Cut the covering from the stab for the slot for the fi n
post and from the bottom of the fi n where shown, being
cautious not to cut into the wood.
❏
5. Slide both wings all the way onto the fuselage.
