19
❏
5. Install and cut the throttle pushrod to the correct length.
Then, connect it to the carburetor arm and the screw-lock
connector on the servo arm.
❏
6. You can set up the throttle now or later to open and
close the carburetor barrel on the engine with the throttle
stick on the transmitter. When ready to lock the pushrod to
the screw-lock connector, use a 2.0 mm hex driver on the
set screw and hold the screw-lock body with pliers so the
set screw can be tightened thoroughly.
Install the Fuel Tank
❏
1. Fit a 3" [ 75 mm ] piece of medium fuel line (not included)
onto the straight pickup tube in the fuel tank stopper. Then,
add the clunk to the line.
❏
2. Fit the stopper assembly into the tank with the vent
tube pointing toward the top of the tank as shown. Tighten
the screw to compress the stopper and seal the tank.
❏
3. Test-mount the tank to the fuel tank/battery tray with
a piece of 1/4" [ 6.5 mm] RC foam rubber in-between and
two 10" [ 250 mm] straps cut from a piece of Great Planes
hook-and-loop strap material (not included).
