tousek
/ EN_TPS-60-PRO_05 / 25. 03. 2020
- 5 -
Height adjustability of the motor (gearwheel)
• The motor is height adjustable:
To adjust the height of the gearwheel, you
have to properly adjust the screw nuts
(M)
on
the threaded bars.
Possible height of the gear center:
193 ± 20mm
height adjustable
M
M
2
10
8
8
9
11
11
2. Installation
Sliding gate operator TPS 60 PRO
General installation notes
Before installing the
Tousek TPS 60 PRO
sliding gate operator we recommend checking the following points:
•
Checking the gate structure:
On a gate which travels on floor rails please check the bottom rollers and the upper guide rollers and make
sure that there is no undue friction or jamming.
On a cantilever gate please check if the gate can be moved out of its end-positions without undue effort.
• The gate must travel in a stable manner without lateral movements of the gate panel.
• Make sure that the gate travels in a regular way without undue friction or jamming along the whole travel length.
•
Make sure that there are stoppers at both ends of the track, preventing the gate from running over its travel
limit.
Technical layout
(1)
Ground plate
(1a)
Cable inlet
(1b)
Slotted holes (4x) for mounting
(2)
Gear wheel
(3)
Emergency release
(4)
Control unit
(5)
Torque sensor
(6)
Motor-/gear unit
(7)
Main switch
(8)
Reed-limit switch
(9)
Emergency-spring switch
(10)
Height-adjustable bracket for
power supply system
(optional)
(11)
Security sensing edge
(optional)
(12)
Housing lock (HPC)
7
1
1b
1a
3
5
6
4
9
12
