- 6 -
tousek
/ E_SLIM-SR-CR_42000904 / 21. 11. 2017
2b. Installing the operator
Installation
Important
•
The operator always has to be installed with the rear
cable inlet facing downwards.
• After installing the mounting parts the operator itself can be
mounted. Before, grease the mounting parts at their pivot
points, as well as the push rod (in extended position)!
• Therefore set the operator
(A1)
motor-sided on the rear
mounting part
(2)
and insert the longer one of both cylindric
bolts
(Z2)
as well as the cover
(D)
from above.
• Open the hexagon socket screw
(K1)
and put the clamping
piece
(K)
on the push rod
(A2).
Position the clamping piece
exactly on the circular nose of the push rod and tighten the
hexagon socket screw.
• Now insert the clamping piece
(K)
in the front mounting part
(1)
and insert the cylindric bolt
(Z1)
and the cover
(D)
from
above.
Note: The push rod can be brought in the desired position
by turning it.
• Tighten the hexagon socket screw
(K1).
D
A2
1
K1
Z1
K
K1
1
Z2
D
2
A1
K
Greasing
of the moving mounting parts and of the push rod
• All the pivot points (the drills of the mounting parts and the corresponding bolts, which allow a
GREASE
defined mounting of the actuator) have to be lubricated with grease before mounting the automation!
• Also spray the push rod (in extended position) with WD40!
WD40
• Let the automation run two or three times (open and close it)
• Grease the automation regularly ( according to the manteinance instructions).
WD40
GREASE
GREASE
