21
ELEVATE
®
ENCOMPASS
TM
OWNER’S GUIDE
ELEVATE
®
ENCOMPASS
TM
OWNER’S GUIDE
The crosspins in the center channel of the tower are for the Leg Pulley System
accessory and for connecting the center pulley to accomplish dead weight pulls.
Connecting the center pulley here will double the resistance compared to when the
center pulley is connected to the glideboard.
NOTE:
Only connect the center pulley to tower crosspins at the same level or
below the arm pulleys.
If you connect the center pulley to the center channel at a level beneath the rails,
use caution to prevent cables from rubbing against the rails. To help prevent cables
rubbing against rails, move the pulleys to the inside high position on the LAT bars.
CONNECTING PULLEYS TO TOWER CROSSPINS IN CENTER CHANNEL
If the cable length is too long for you to achieve full range of motion for your
exercise, you can connect the center pulley to a lower crosspin further down the
tower.
CONNECTING PULLEYS
WARNING
Never connect the center pulley above the arm pulleys on the
ELEVATE Encompass as the force may cause the rails to be
pulled up out of engagement from the tower.
