Toshiba TOSDIC-CIE DS, Instruction Manual

Page: 66 / 158

3. System Configuration Unit and Module
52
UTBA61 terminal block (TB1, TB2) signal table
TB1
PI/O module
TB2
PI/O module
SAI06
option board
FIVC21/22
SAI06
option board
FDA01
SAO06 SPI06
SAI06
option board
FIVC21/22
SAI06
option board
FDA01
SAO06 SPI06
FG (0) FG FG FG FG FG (0) FG FG FG
1 AI1 (+) AI1 (+) AO1 (+) PI1 (+) 1 AI5 (+) AI5 (+) AO5 (+)
2 AI1 (-) AI1 (-) AO1 (-) PI1 (-) 2 AI5 (-) AI5 (-) AO5 (-)
3 DP1 3 DP5
4 Shield 1 Shield 1 Shield 1 4 Shield 5 Shield 5 Shield 5
5 AI2 (+) AI2 (+) AO2 (+) PI2 (+) 5 AI6 (+) AI6 (+) AO6 (+)
6 AI2 (-) AI2 (-) AO2 (-) PI2 (-) 6 AI6 (-) AI6 (-) AO6 (-)
7 DP2 7 DP6
8 Shield 2 Shield 2 Shield 2 8 Shield 6 Shield 6 Shield 6
9 AI3 (+) AI3 (+) AO3 (+) PI3 (+) 9 AI7 (+) AI7 (+) AO7 (+)
10 AI3 (-) AI3 (-) AO3 (-) PI3 (-) 10 AI7 (-) AI7 (-) AO7 (-)
11 DP3 11 DP7
12 Shield 3 Shield 3 Shield 3 12 Shield 7 Shield 7 Shield 7
13 AI4 (+) AI4 (+) AO4 (+) PI4 (+) 13 AI8 (+) AI8 (+) AO8 (+)
14 AI4 (-) AI4 (-) AO4 (-) PI4 (-) 14 AI8 (-) AI8 (-) AO8 (-)
15 DP4 15 DP8
16 Shield 4 Shield 4 Shield 4 16 Shield 8 Shield 8 Shield 8
17 24 Vdc
(external)
24 Vdc
(external)
17
18 0 Vdc
(external)
0 Vdc
(external)
18
19 24 Vdc
(external)
24 Vdc
(external)
19
20 0 Vdc
(external)
0 Vdc
(external)
20
NOTICE:

Before mounting the PI/O module, always check whether the connected signal matches it.

If a PI/O module is mounted and an erroneous signal is connected, the PI/O module or external
sensor may got damage.

The shields on each terminal block (4 terminals) are all connected to each FG terminal
internally. The shields and the PI/O are grounded by grounding the FG terminals.
Always ground them.

Otherwise parts will be damaged or system will be malfunction.

Do not connect an external signal line or a power line to an open terminal.

Doing so may cause parts to be damaged or malfunction.

When branching the external power supply connected to pins 17 and 18 of the terminal block
(TB2) from pins 19 and 20, make sure that the maximum power-on current is within 2 A.

Otherwise, the current may run short thus resulting in burning of the pattern.