Toshiba RSM 100, Instruction Manual, Page: 25 / 173

⎯
24
⎯
6 F 2 S 0 7 1 5
“Copy”: After inserting, the selected line remains there.
<Position>
“Insert rows above”: The item is added above the selected line.
“Insert rows below”: The item is added below the selected line.
<Save item>
Click the [Save] button on the [Choose IP address] screen when the changed items are saved in the
file. Once the file for IP address setting is saved, the file is automatically used when connecting. If
the specified file is not found because it is deleted or etc., the file selection dialog is displayed.
After editing, select an IP address for connection and click the “OK” button. Then a progress bar is
displayed to connect the relay. If it has failed to connect the relay, the following message appears:
“Check Ethernet connection and TCP/IP settings. If you click the ‘Retry’, RSM100
communicates with the relay using current communication settings of RSM100.”
If the message above appears, check the followings:
•
Check that DC supply for the relay is ON.
•
Check that the “Address/Parameter”(network parameter) setting of the relay is completed.
The network parameter of the relay such as IP address, etc. must set before. The network
parameter is set by the LCD panel or by the RSM100 with local connection. The network
parameter cannot be changed by RSM100 via Ethernet. (The defaults of network parameter
setting are all the same.)
•
Check that the selected IP address meets with the IP address setting of the relay.
•
Check that the connector for Ethernet cable is tightly inserted. If the message still appears, try
to replace the cable
•
Check that the setting and operation status of network devices such as HUB, Router, etc.
•
In a network using dialup router, etc., the timeout may occur at the first connection because it
takes time for connection. In this case, try again or try to connect RSM100 after connecting the
network line.
Editing only IP address:
When you choose the [TCP/IP Settings] of the [Communication] at the top menu, the following
screen is displayed. IP address can be edited as described above in this screen. However, it cannot
be connected to the relay.