Toshiba RSM 100, Instruction Manual, Page: 119 / 173

⎯
118
⎯
6 F 2 S 0 7 1 5
■
Selecting Options
This part describes how to select the options.
《
Note for Operation
》
●
The following selections are available.
・
Hard Copy Mode When a color printer is concocted to the PC, you
can select color or monochrome printing to make a
hard copy.
・
Phase You can select the leading display or delay display
for the phase difference of waveforms.
・
Unit at Start You can select a unit for the time displayed when a
waveform data is displayed.
・
Value You can select the primary value display or the
secondary value display for the measurement and
analysis values.
・
Fault Section Calculation You can select whether the fault time is calculated
automatically at the same time with the waveform
display or not.
●
The option selections are common to all the waveform data.
《
Operating Procedure
》
①
On the [Set] menu, click [Option].
②
Select an option that you want to select for each item.
Note: When no voltage is input, remove the check (
ν
) in the “Fault Selection
Calculation” checkbox.
③
Click
【
OK
】
button.
･
The selected options are set.
2-6