Owner’s Manual
21-EN
To recognize the position of
the corresponding indoor unit
though the indoor “UNIT No.”
is known
Check the position during operation stop.
(Stop operation of the set.)
1
Push
+
buttons simultaneously for
4 seconds or more.
After a while, the display part flashes and the
display appears as shown below.
In this time, the position can be checked because
fan of the indoor unit operate.
• For the group control, the indoor “UNIT No.” is
displayed as [
] and fans of all the indoor
units in the group control operate.
Check the displayed “CODE No.” is [
01
].
• When the “CODE No.” is other than [
01
], push
button to erase the display and repeat
procedure from the first step.
(After pushing
button, operation of the remote
controller is not accepted for approx. 1 minute.)
2
In the group control, every time
button is pushed, the indoor “UNIT No.” in
the group control is displayed in order.
In this time, the position of the indoor unit can be
confirmed because only fan of the selected indoor
unit operate.
(For a group control, No. of the firstly displayed
indoor unit becomes the header unit.)
3
After confirmation, push
button to return
the mode to the usual mode.
When
button is pushed, the display disappears
and the status becomes the usual stop status.
(When
button is pushed the operation from the
remote controller is not accepted for approx. 1
minute.)
2
1,3
1
The content of "SET DATA" displayed with
“CODE No.” [10] changes depending on the type
of indoor unit.
Summary of Contents for RBC-AMTU31-E
Page 29: ...Owner s Manual 28 EN ...
Page 30: ...Owner s Manual 29 EN ...
Page 31: ...Owner s Manual 30 EN ...
Page 32: ...DEB9509002 ...
