Owner’s Manual
19-EN
7
Address setting
[Procedure example]
Manual address setup
procedure
While the operation stops, change the setup.
(Stop the operation of the unit.)
1
Push
+
+
buttons simultaneously
for 4 seconds or more. After a while, the
display part flashes as shown below. Check
the displayed “CODE No.” is [10].
• When the “CODE No.” is other than [
10
], push
button to erase the display and repeat
procedure from the first step.
(After pushing
button, operation of the
remote controller is not accepted for
approx. 1 minute.)
(For a group control, No. of the firstly displayed
indoor unit becomes the header unit.)
2
Every time
button is pushed, the
indoor “UNIT No.” in the group control is
displayed in order. Select the indoor unit of
which setup is changed.
In this time, the position of the indoor unit of which
setup is changed can be confirmed because fan of
the selected indoor unit operate.
3
1. Specify “CODE No.” [
12
] with
buttons.
(“CODE No.” [
12
]: Line address)
2. Change the line address from [
3
] to [
2
] with
buttons.
3. Push
button.
In this time, the setup finishes when the display
changes from flashing to lighting.
4
1. Specify “CODE No.” [
13
] with
buttons.
(“CODE No.” [
13
]: Indoor address)
2. Change the indoor address from [
3
] to [
2
] with
buttons.
3. Push
button.
In this time, the setup finishes when the display
changes from flashing to lighting.
2,6
1
7
3
-1,
4
5
6
-1,
-1,
7
3
-3,
4
-3,
3
-2,
4
-2,
5
-2
5
-3,
The content of "SET DATA" displayed with
“CODE No.” [10] changes depending on the type
of indoor unit.
Indoor “UNIT No.” before setup change is displayed.
Indoor “UNIT No.” before setup change is displayed.
Summary of Contents for RBC-AMTU31-E
Page 29: ...Owner s Manual 28 EN ...
Page 30: ...Owner s Manual 29 EN ...
Page 31: ...Owner s Manual 30 EN ...
Page 32: ...DEB9509002 ...
