Toshiba ras-m07g3dv-e, Service Manual

Page: 39 / 94

– 38 –
9-3. Auto Restart Function
This indoor unit is equipped with an automatic restarting function which allows the unit to restart operating with the
set operating conditions in the event of a power supply being accidentally shut down.
The operation will resume without warning three minutes after power is restored.
This function is not set to work when shipped from the factory. Therefore it is necessary to set it to work.
9-3-1. How to Set the Auto Restart Function
To set the auto restart function, proceed as follows:
The power supply to the unit must be on ; the function will not set if the power is off.
Press and hold the TEMPORARY button on the signal receiving unit for 3 seconds to set the operation (3 beep
sound and OPERATION lamp blink 5 time/sec for 5 seconds).
The unit then restarts operating automatically in the event of power supply being accidentally shut down.
• When the unit is standby (Not operating)
• When the unit is in operation
Operation Motions
Press [TEMPORARY] button for more than
three seconds. (Less than 10 seconds) The unit is on standby.
↓
The unit starts to operate. The green indicator is on.
↓
After approx. three seconds, release
[TEMPORARY] button from being pushed.
The unit beeps three times and
continues to operate. The green indicator flashes for
5 seconds.
If the unit is not required to operate at this time, press
[TEMPORARY] button once more or use the remote controller to
turn it off.
Operation Motions
Press [TEMPORARY] button for more than
three seconds. (Less than 10 seconds) The unit is in operation. The green indicator is on.
↓
The unit stops operating. The green indicator is turned off.
↓
After approx. three seconds, release
[TEMPORARY] button from being pushed.
The unit beeps three times. The green indicator flashes for
5 seconds.
If the unit is required to operate at this time, press [TEMPORARY]
button once more or use the remote controller to turn it on.
TEMPORARY
button
TEMPORARY
button