No.
Part name
P
rocedure
s
Remarks
Cross flow fan
<To re-installation>
1) To incorporate the fan motor and the
motor into the position in the following
figure.
- Install the cross flow fan so that the right
end of the 1st joint from the right of the
Cross flow fan is keep 3.5mm from
closed wall of the main unit.
- Holding the set screw, install the
cross flow fan so that flat area on shaft of
the fan motor comes to the mounting hole
of the set screw.
1)
Follow the procedure item
3
and
4 .
2)
Loosen the set screw of the cross flow fan.
3)
Condition for remove bearing base
Type A:
Remove 2 fixing screws from
bearing
b
ase after that remove it by hold, press and
pry out from the main unit
Type B:
Remove 4 fixing screws from bearing
base then remove if from the main unit
4)
Lift up the heat exchanger follow the figure.
Pull out the left hand side until the cross flow
fan is released from the shaft of the fan
motor
and then pull out the lower side of
heat
exchanger follow the figure.
Bearing base
Heat exchanger
Cross flow fan
Cross flow fan
Heat exchanger
Bearing base
Cross flow fan
Hins seal eva
Heat exchanger
Screw
Type : A (For 05,07,10,13k)
Type : B (For 16,18k)
3.5 mm
Cross flow fan
Set screw
Fan motor
Body back
5.0 mm
Cross flow fan
Set screw
Fan motor
Body back
Type : B (For 16,18k)
Type : A (For 05,07,10,13k)
Bearing base
Back body
10
- 114 -
