TS-L532A (SD-R6472) Rev.1.1
22 / 28
7.2.7. Peak in accessing
1800 mA (DVD/CD)
(Excluding Spike Current)
*Spike: 1 ms or less duration
7.2.8. Write
1040 mA (CD-R 24X)
700 mA (CD-RW 4X)
850 mA (High Speed CD-RW 10X)
840 mA (Ultra Speed CD-RW 10X)
970 mA (DVD-R 8X)
890 mA (DVD-RW 4X)
970 mA (DVD+R 8X)
860 mA (DVD+RW 4X)
8. CD Audio (Test condition: Ordinary temperature)
8.1. Analog Output --- in case that the attenuator is set at 0 db by the command ---
(1) Output Level
0.8 V (rms) Typ.
(2) Type
Unbalanced
(3) Load Impedance
47 kOHM min
(4) Frequency Response
20 Hz ~ 20 kHz ± 3.0 dB (at 47 kOHM Load)
(5) Distortion
0.04 % Max. (at 1 kHz w/20 kHz LPF)
(6) Signal to Noise Ratio
80 dB Typ (IEC179 A-Weighted)
8.2. Audio Modes
(1) A command can be used to select a mode from 16 available, such as ‘Stereo’, ‘Lch Mono’,
‘Rch Mono’, and ‘Mute’ etc. Default mode is ‘Stereo’.
(2) A command can be used to select an attenuator (line output) level from 16 levels.
Default level is 0 dB.
9. Device Configuration Jumper
9.1. Master Mode Setting
Short-circuit the PIN 47 and PIN 48 of I/O connectors.
9.2. Slave Mode Setting
Open the PIN 47 of I/O connectors.
(Optional)
9.1. Master Mode Setting
Open the PIN 47 of I/O connectors.
9.2. Slave Mode Setting
Short-circuit the PIN 47 and PIN 48 of I/O connectors.
Summary of Contents for R6472 - DVD±RW Drive - IDE
Page 16: ...TS L532A SD R6472 Rev 1 1 10 28 Unit mm Figure 5 1 External Dimensions ...
Page 17: ...TS L532A SD R6472 Rev 1 1 11 28 Unit mm Figure 5 2 External Dimensions ...
Page 19: ...TS L532A SD R6472 Rev 1 1 13 28 Figure 6 Configuration ...
Page 33: ...TS L532A SD R6472 Rev 1 1 27 28 Annex 1 ...
