Toshiba PDR-M500, Service Manual

Page: 15 / 49

10
Install the Photo Sensor
ASSY H500 to the
camera.
11
Install the Flash Open
Switch A440. Then
install the Flash PCB
KIT U300 into the
camera.
Check the Flash
Open Switch
A440 can work
well before
assemble the Flash
PCB KIT U300.
12
Drive the screw 01635-
000 to the Flash PCB
KIT U300.
Screw driver
13
Drive the screw 01635-
000*4 to the Flash PCB
KIT U300.
Screw driver
14
Connect the wire of
Photo Sensor H500 to
Flash PCB KIT U300.
The Flex Cable
Main-Mode H610
might be inserted
on the Mode PCB
ASSY U510 first.
Tweezers
15
Connect the Flex Cable
Main-Mode H610 to
Main PCB ASSY U100.
Put down the Main PCB
on camera. Be careful of the
male & female
connectors of
Flash PCB KIT
and Mode PCB.
Tweezers
16
Screw up the screws
01635-000*3 of Main
PCB ASSY U100.
Watch out the
connectors at the
left-hand side of
Main PCB ASSY
not to misaligned.
Screw driver
17
Install the wires from
Flash PCB KIT U300 to
the Main PCB ASSY
U100. Install the FPC
cable of Lens.
Tweezers
18
Solder the wires on
Main PCB ASSY U100.
Soldering iron
13