10
TOSHIBA 1108150401_EN
EN
Start
1
1
1
1
1
START/STOP button
Press this button to start the air conditioner.
2
2
2
2
2
Mode select button (MODE)
Select DRY
.
3
3
3
3
3
Temperature button (
)
Set the desired temperature.
•
The fan speed display indicates
•
The
lamp (green) on the display panel of the indoor unit
lights, and operation starts after approximately 3 minutes.
Stop
START/STOP button
Press this button again to stop the air conditioner.
DRY OPERATION
If you select HEAT in a Cool Only model, disagreement in operation mode occurs.
Change the operation mode with the MODE button on the Wireless remote control. (
see page 3.)
Start
1
1
1
1
1
START/STOP button
Press this button to start the air conditioner.
2
2
2
2
2
Mode select button (MODE)
Select Cool
, Heat
, or Fan only
.
3
3
3
3
3
Temperature button (
)
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4
4
4
4
4
Fan speed button (FAN)
Select one of LOW
, LOW
+
, MED
,
MED
+
, HIGH
.
•
The
lamp (green) on the display panel of the indoor unit
goes on. And operation starts after approximately
3 minutes.
(If you select FAN ONLY mode, the unit will start immediately.)
•
The
: Fan only mode does not control temperature.
Therefore, perform only steps
1
,
2
and
4
to select this mode.
Stop
START/STOP button
Press this button again to stop the air conditioner.
COOLING/HEATING/FAN ONLY OPERATION
PRESET
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
3
4
1
2
PRESET
FAN
MODE
AUTO
ON
OFF
SET
CLR
ECO
Hi-POWER
TIMER
CLOCK CHECK
RESET
FILTER
START/STOP
FIX
MEMO
SWING
3
1
2
Regarding models without auto-changeover (cooling/heating) function, heating operation takes priority. When
“cooling operation” is sent while another indoor unit in the same system is heating, a receive sound arises but
only blowing operation is enabled.
CAUTION
01(EN)_1108150401 P08-13
05.1.17, 12:20
10
