Toshiba e-STUDIO 161, Operator'S Manual

Page: 22 / 76

BEFORE USING THE MACHINE
16
Envelopes
•
Do not use the following envelopes, as misfeeds will occur.
•
Envelopes with metal tabs, clasps, strings, holes, or windows.
•
Envelopes with rough fibres, carbon paper, or glossy surfaces.
•
Envelopes with two or more flaps.
•
Envelopes with tape, film, or paper attached to the flap.
•
Envelopes with a fold in the flap.
•
Envelopes with glue on the flap to be moistened for sealing.
•
Envelopes with labels or stamps.
•
Envelopes that are slightly inflated with air.
•
Envelopes with glue protruding from the seal area.
•
Envelopes with part of the seal area peeled off.
CHANGING A TRAY’S PAPER SIZE SETTING
Follow these steps to change a tray’s paper size setting.
1
Hold down the [PAPER SIZE ENTER]
key ( ) for more than 5 seconds to
set the selected paper size.
The currently selected
paper feed location
indicator will blink and the
corresponding paper size
(which is currently set)
indicator will light
steadily. All other
indicators will go out.
2
If the machine has two paper trays,
use the [TRAY SELECT] key (
) to
select the paper tray for which you
wish to change the paper size setting.
Each time the [TRAY
SELECT] key (
) is
pressed, a paper tray will
be indicated with a
blinking paper feed
location indicator.
3
Use the [ORIGINAL SIZE ENTER] key
(
) to select the paper size.
The indicator of the
selected paper size lights
up.
• The paper size setting cannot be changed when the machine has stopped temporarily due to running out of
paper or a misfeed, or during interrupt copying.
• During printing (even in copy mode), the paper size setting cannot be changed.
• A5 (ST) size paper can only be selected in upper paper tray.
• Do not load paper that is a different size than the paper size setting. Copying will not be possible.
Note