Toshiba AW-9500SBJ/SBK/SBX, Service Manual

Page: 33 / 52

– 32 –
1) Open the lid and remove the control panel
according to the steps 1) to 4) of (1)
Program timer.
2) Detach the connector from the reed switch.
3) Remove 2 screws of the top cover rear and
lift top cover front. (Photo. 26)
4) Remove the screw and carefully remove the
reed switch with the metal place (covered
with tape).
1) Remove the rear lid.
2) Disassemble the pulsator and spin basket
according to the steps of (10) Pulsator and
(11) Wash tub.
3) Remove the wires within the cabinet (the
lead wire on the top cover side and the
connector of the lead wire on the cabinet
side) and the grounding wire (flat washer
with
ϕ
4 screw). (Photo. 27)
4) Remove the air tube from the air trap.
(Photo. 27)
5) Remove the (outer) drain hose from the
hose outlet, and cut the root of the inner
drain hose from the valve case using a
cutter knife and remove it.
6) Remove the suspensor rod from the cabinet
holder and tub holder. (Photo. 28)
(Lifting the tub with one hand will make it
easy to float the suspensor rod.)
7) Lift the tub up and out.
8) Turn the tub upside-down.
9) Remove the drain valve motor according to
the steps 2) to 3) of (6) Drain valve motor.
* Follow the reverse order of removal.
Note 1 : Reed switch lead wires should go along
the main lead unit.
Note 2 : Lid opening detection dimension should
be checked
10 - 40 mm as shown
Fig. 3.
(13) Reed switch
(14) Tub
(Photo. 26)
(Photo. 28)
(Photo. 27)
Parts
Procedure ( : Notes)
Illustrations