7
Removing the Pedestal Stand
1)
Carefully lay the front of the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave
the stand protruding over the edge of the surface.
Note:
Extreme care should always be used when
removing the pedestal stand to avoid damage to
the LCD panel.
2) Remove the stand screws shown in the diagram
below.This will allow removal of the pedestal stand.
3) Once you have removed the screws holding the
pedestal stand in place, remove the pedestal stand
from the TV.
L3400U Series
(Sample Illustration)
(Sample Illustration)
CAUTION:
Always place the TV on the floor or a
sturdy, level, stable surface that can support the
weight of the unit. To secure the TV, use a sturdy strap
from the hook(s) on the rear of the TV to a wall stud,
pillar, or other immovable structure. Make sure the
strap is tight, secure, and parallel to the floor.
FCC Declaration of Conformity
Compliance Statement (Part 15):
Toshiba 40L3400U and 50L3400U Television
models comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
The party responsible for compliance to these rules is:
Toshiba America Information Systems, Inc.
9740 Irvine Blvd., Irvine, CA 92618. Ph: 800-631-3811
Note:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by removing and applying
power to the equipment, the user is encouraged to try
to correct the interference by one of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician
for help.
Caution:
Changes or modifications to this equipment
not expressly approved by Toshiba could void the
user’s authority to operate this equipment.
Wireless Radio
For product available in the USA/Canada market, only
channel 1-11 can be operated. Selection of other channels is
not possible. The device could automatically discontinue
transmission in case of absence of information to transmit,
or operational failure. Note that this is not intended to
prohibit transmission of control or signaling information or
the use of repetitive codes where required by the technology.
If this device is going to be operated in 5.15-5.25GHz
frequency range, then it is restricted to an indoor
environment only.
Important
: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
this equipment.
This device and its antenna(s) must not be co-located
or operating in conjunction with any other antenna or
transmitter.
VESA Mounting Pattern
Hook Sturdy strap
(as short as possible)
Two stand screws
40” TV.
VESA Mounting Pattern
Hook Sturdy strap
(as short as possible)
Two stand screws
50” TV.