Instructions handbook
19
FILLER WORKING CONTROL
When the filling machine is in operation it is require the tank level control to the operator,
especially in the models without floating device, if the level of the product in tank is going too
down you can act on the by-pass valve (Z), opening the valve the pump is sucking less quantity of
product and closing it it is sucking more.
10.4 – Using the machine with optional devices
USE OF THE FILLER WITH SATURATOR
The machine equipped with saturator, that can
also be installed in a second time, do not
require any particular shrewdness, but only
the connection that has to be made as follows:
Connect the gas cylinder pipe with pre-
heating element to valve (A) on the saturator,
•
Open the valve of the gas cylinder and
regulate the pressure between 0,2 and
2,5 Bar, accordingly to the product
needs.
ATTENTION: It is very important that
the product to gas has a temperature not
higher than
5°C.
Figure 13 – Saturator
USE OF THE FILLER WITH STERILIZATION CARTRIDGE
The machine equipped with sterilization
cartridge do not need any particular care as it
is placed in line on the product enter. It is
only necessary to take care of the cartridge
maintenance that has to be removed at the end
of the working cycle and kept into a solution
of water with Peracetric acid at 1%.
Figure 14 – Dismantling the cartridge
