Figure 46
1.
Engine oil
2.
Funnel and hose
Important:
Add the oil very slowly and do not
block the opening of the filler hole (Figure 47).
If you add oil too fast or block the hole, the oil
could back up and foul the air intakes, causing
engine damage.
Figure 47
1.
Note the clearance left in the filler opening.
5. Replace the dipstick and install the front engine
panel.
6. Start the engine and run it at idle for 5 minutes.
7. Shut off the engine.
8. Wait 3 minutes and check the oil level.
9. Add oil, if required, to bring the level to the upper
hole on the dipstick.
10. Replace the dipstick and , filler cap, and the front
engine panel.
11. Check for leaks.
Important:
Do not overfill the crankcase with
oil because this may cause engine damage.
Changing the Engine Oil Filter
Service Interval:
After the first 50 hours
Every 200 hours
1. Drain the oil from the engine; refer to Changing the
Engine Oil.
Place a drip pan beneath the oil drip tray to receive
oil from the oil filter and oil passages in the engine.
2. Turn the filter counterclockwise to remove it
(Figure 48 and Figure 49).
Note:
Dispose of the oil filter properly. Recycle in
accordance with local codes.
3. Before installing the filter, lightly oil the gasket on
the filter with fresh, clean oil. Screw the filter on by
hand until the gasket contacts the oil filter adapter.
Tighten 1/2 to 3/4 turn more.
4. Add oil; refer to Adding Engine Oil.
Figure 48
1.
Oil filter
2.
Right side of machine
38
Summary of Contents for Z580-D Z Master 74266
Page 65: ...Schematics g012068 Wire Diagram Rev A 65 ...
Page 66: ...Notes 66 ...
