1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Tilt the seat forward, loosen the bolts and remove
the front engine panel (Figure 69).
G012347
1
1
2
Figure 69
1.
Bolts
2.
Front engine panel
4. Remove the spring from the idler arm (Figure 70).
5. Remove the clutch stop bracket.
6. Remove the old PTO drive belt.
7. Install the PTO drive belt around the clutch pulley
and the gearbox pulley (Figure 70).
8. Install the rubber clutch stop.
9. Install the spring to the idler arm (Figure 70).
10. Install the front engine panel.
Figure 70
1.
Gear box
4.
Clutch
2.
Spring
5.
Rubber clutch stop
3.
Spring loaded idler pulley
6.
PTO Drive belt
Replacing the Pump Drive Belt
Service Interval:
Every 50 hours—Check the pump
drive belt.
Note:
Remove the PTO drive belt first if the pump
drive belt needs to be replaced.
1. Tilt the seat forward, loosen the bolts and remove
the front engine panel.
2. Remove the PTO drive belt.
3. Remove the spring from the idler arm (Figure 71).
4. Install the new belt around the engine and hydro
pump pulley (Figure 71).
5. Install the PTO drive belt.
6. Install the spring to the idler arm (Figure 71).
7. Install the front engine panel.
50
Summary of Contents for Z580-D Z Master 74266
Page 65: ...Schematics g012068 Wire Diagram Rev A 65 ...
Page 66: ...Notes 66 ...
