Workman MDX--D
Electrical System
Page 5 -- 11
Fusible Links
The Workman MDX--D uses four (4) fusible links for cir-
cuit protection. Three (3) of these fusible links are in-
cluded in a wire harness that connects the starter B+
terminal to the vehicle wire harness (Fig. 12). The re-
maining fusible link is included in the engine wire har-
ness and connects the starter G terminal to the engine
run solenoid pull coil. If any of these links should fail, cur-
rent to the protected circuit will cease. Refer to the elec-
trical schematic and wire harness drawings in Chapter
7 -- Electrical Drawings for additional circuit information.
Testing
Make sure that ignition switch is OFF. Disconnect nega-
tive battery cable from battery terminal and then discon-
nect positive cable from battery (see Battery Service in
the Service and Repairs section of this chapter). Locate
and unplug fusible link connector. Use a multimeter to
make sure that continuity exists between the fusible link
terminals. If a fusible link is open, replace the link.
After testing is complete, make sure that fusible link is
securely attached to engine component and wire har-
ness. Connect positive battery cable to battery terminal
first and then connect negative cable to battery.
Figure 12
FUSIBLE LINK
FUSIBLE LINK
FUSIBLE LINK
El
ec
tri
cal
Sy
st
em
Summary of Contents for Workman MDX-D
