Toro Workman HD Series, Service Manual, Page: 98 / 318

Workman HD Series Page 6 -- 22 Drive Train
Transaxle Service
Transaxle Disassembly
NOTE: Item numbers in figures are shown in order of
disassembly; for example, remove item 1 first, then item
2, etc. assemble transaxle in reverse order; for example,
install item 1 last.
1. Remove extension spring (item 1).
2. Loosen and remove nine (9) flange head screws
(item 2) and remove bell housing assembly from trans-
axle.
3. Thoroughly clean outside surface of transaxle.
4. Loosen flange head screws (items 1 and 2) and re-
move fork shaft case (item 3) from center plate. Note
location of longer flange head screw (item 1). Be careful
when removing cover as steel balls inside are spring
loaded.
5. Hold your hand over the area and shift R--1 and 2--3
levers to move rails outward so balls (item 3), springs
(item 2) and spindle (item 1) can be removed.
6. Inspect fork shaft case for cracks or damage and re-
place if necessary.
1
2
Figure 24
1
3
2
2
2
Figure 25
1
2
3
Figure 26